A campfire needs three sizes of fuel, air and a little patience. Most fires that won't catch fail for the same reasons: wood that's too big, too wet or packed too tight. Here's how to build one that lights the first time, following the steps the U.S. Forest Service (through Smokey Bear) and the National Park Service give campers, and how to make sure it's really out when you're done.

Before you light anything

Check the fire rules. Each park, forest and campground sets its own, and they change with the weather. In a dry, windy spell campfires may be banned outright. Look up the current fire restrictions for the national forest, BLM office or park, or ask at the visitor center or the campground host. Even when there's no ban, the Forest Service suggests skipping the fire when fire danger is high: it says nine out of ten fires are caused by people.

Check the wind. Don't build a fire in hot, dry or windy weather. Sparks carry.

Get your firewood near where you'll burn it. Firewood carries tree-killing insects and diseases. The Don't Move Firewood campaign's rule of thumb is that 10 miles or less is best and 50 miles is too far. Packaged firewood with a USDA APHIS or state heat-treatment seal is considered safe to move; "kiln-dried" on its own is not the same thing. Collecting dead wood on the ground is allowed in some places and banned in many national parks, so check first.

What you need

  • Water and a bucket (or a big jug), plus a shovel. You need both to put the fire out.
  • Tinder: dry grass, pine needles, dry leaves and small twigs, or a fire starter (the NPS suggests paraffin-soaked cotton balls or shredded paper). See how to make fire starters.
  • Kindling: dry sticks smaller than about 1 inch around.
  • Logs: larger pieces of dry, split wood. Split wood catches faster than whole rounds because bark burns poorly.
  • Matches or a lighter. Waterproof matches are worth having.
  • A phone: if the fire escapes the ring, call 911.

Collect about twice as much tinder and kindling as you think you'll need before you strike a match. A fire that dies while you hunt for sticks is a common mistake.

Step 1: Pick the spot

Use the existing fire ring at a campsite whenever there is one. If there isn't:

  • Choose a flat, open spot with nothing overhead and out of gusty wind.
  • Keep the fire at least 15 feet from tents, gear, bushes and low branches, with the tent upwind. Smokey Bear also asks for overhead clearance of at least three times the height of the flames.
  • Clear an area at least 10 feet across around the fire.
  • Where building a new pit is allowed, dig down about 1 foot and circle it with rocks or a metal ring.

Step 2: Lay the fire

Put a loose double handful of tinder in the center of the ring. Then arrange the kindling over it in one of four ways. All of them leave gaps, because a fire needs air: a tight pile of wood smothers itself.

Lay How Best for
Teepee Lean kindling over the tinder like a tent, with a gap on the windward side to light through Cooking
Lean-to Push one long stick into the ground at an angle over the tinder and lean smaller kindling against it Cooking
Cross Crisscross kindling over the tinder in layers A long-lasting fire
Log cabin Stack kindling in a square around the tinder, each layer at right angles, and top it with the smallest pieces A long-lasting fire

Smokey Bear recommends the teepee and lean-to for cooking, and the cross and log cabin for a fire that lasts. For foil packet dinners and a hobo dinner, let the fire burn down to glowing coals before you cook. More ideas in our campfire recipes.

Step 3: Light it

  1. Light the tinder at the bottom with a match or lighter.
  2. Blow gently at the base of the flame to feed it air.
  3. As the kindling catches, add a few bigger sticks, then the first logs. Lay them on loosely so air still gets through.

Never use gasoline or other accelerants. The National Park Service allows only lighter fluid, and only if the park permits it, and never squirted onto flames or embers. Smokey Bear says to skip flammable liquids altogether. With dry tinder and kindling you won't need them.

Step 4: Keep it going

  • Feed it gradually. Add dry wood as the fire burns down, and keep it small enough to control.
  • Stack spare wood upwind, so a gust doesn't carry sparks into your woodpile.
  • Burn only wood. No trash, aerosol cans, pressurized containers, batteries, glass or aluminum cans; plastic gives off toxic smoke.
  • Never leave it unattended, not even for a quick walk, and keep the water bucket close.
  • Keep children and pets under close watch.
  • Watch your clothes. Synthetic fabric melts; use long cooking tools with insulated handles.

Getting a stubborn fire going

If the fire smokes and sputters, the wood is too wet or too big, or the fire can't breathe. Wet wood smokes much more than dry wood. Pull the logs back, add more dry kindling, and split larger pieces thinner to expose the dry inside. Rebuild with more gaps and blow at the base again.

Step 5: Put it out cold

Put the fire out well before you go to bed or leave camp: gray or white coals can stay hot for hours and flare up in the wind. Smokey Bear's method:

  1. Drown: pour plenty of water over the fire until the hissing stops.
  2. Stir: use the shovel to mix the water into the ashes and embers, and scrape the burned sticks and logs so no embers are left smoldering, not just the red ones.
  3. Drown again: keep adding water (and dirt or sand) until everything is cool.
  4. Feel: hold the back of your hand over the ashes. If you feel heat, repeat. Don't leave until it's cold.

No water? The NPS fallback is to spread the coals out and keep stirring dirt or sand into them until they're out. Just kicking dirt over the fire can bank the coals and keep them hot even longer. Water is always the better choice; Smokey Bear warns that dirt or sand alone isn't enough.

If a fire gets away from you, get clear, note your location and call 911. With no cell service, tell the nearest ranger or campground host. The Forest Service says not to try to put out a spreading fire by yourself.

How to start a fire in a fire pit

A backyard or patio fire pit works the same way as a campfire ring:

  1. Check your city or county's burn rules and any burn ban first; many places restrict open burning.
  2. Set the pit on a clear, level spot, well away from the house, fences, overhanging branches and anything that burns.
  3. Put tinder in the middle, lay kindling over it as a teepee or log cabin, and light the tinder.
  4. Add split logs once the kindling is burning well, and keep the fire small enough for the pit.
  5. Keep a bucket of water or a hose ready, and drown and stir the ashes when you're done.

How to start a bonfire

A bonfire is a big campfire, built up the same way: tinder, kindling, then logs, added gradually so it stays under control. Size is the problem. The NPS warns not to assume a bonfire is okay in a busy campground full of kids, RVs and trees, so ask the campground host about size limits or an area set aside for fires. On the beach or in the backcountry, the land manager's rules decide whether you can have one at all. Keep more water and a shovel close than you would for a small fire, and give it the same drown-stir-feel treatment at the end.

Where campfire rules are strict

Dispersed sites on BLM and national forest land often have no fire ring, and seasonal restrictions are common in the West. Our dispersed camping guide covers how fire restrictions work there. For everything else to pack, including the water bucket, shovel and fire starters, see our camping checklist.