Most modern tents go up the same way: footprint, tent body, poles, rainfly, stakes and guylines. Once you've done it twice it takes ten minutes. The first time, in fading light and a breeze, it can take an hour. Here's the order that works, based on the setup advice of tent makers Big Agnes and MSR and the Bureau of Land Management. Your tent's own instructions come first wherever they differ.
Before the trip: pitch it at home
Set the tent up once in your yard or a park before you go. The BLM's advice is to practice at home and find any problems while you can still fix them: a missing pole section, a bent stake, a torn mesh panel, a zipper that sticks. It also tells you how long setup takes, so you don't arrive at camp at dusk.
Count the parts as you pack: tent body, poles, rainfly, footprint, stakes (and a few spares), guylines and the instruction sheet.
Step 1: Choose the spot
At a campground, pitch on the tent pad or the cleared area of your site. Elsewhere:
- Flat and clear. Big Agnes looks for ground that is flat and relatively free of debris. Sweep away pine cones, sticks and stones before you lay anything down.
- Not in a low spot. Pick ground high enough to stay out of rising water or a flash flood. A dip that looks cozy is where rain collects.
- Nothing dead overhead. Stay out from under dead trees and dead branches.
- Away from water. Leave No Trace, as published by the NPS, says to camp at least 200 feet from lakes and streams. Some parks set their own distance, so check the park's rules.
- On a durable surface. Designated campsites, rock, gravel, sand, dry grass or snow. "Good campsites are found, not made": don't clear plants or dig trenches.
- Mind the wind. Big Agnes points the foot of the tent (the narrow end) into the prevailing wind. The BLM suggests keeping the door away from the wind so campfire smoke doesn't blow in.
Step 2: Lay down the footprint
A footprint (or ground cloth) protects the floor from rocks and wear. MSR suggests laying it down first and using it to check for a flat spot before the tent goes up.
- Coated side up. MSR puts the shiny, coated side facing up.
- No edges sticking out. Big Agnes makes its footprints about 2 inches smaller than the tent floor, and MSR says the footprint shouldn't extend beyond it: an edge that sticks out catches rain and channels it under the tent. If you use a plain tarp, fold the extra under so it's hidden beneath the floor.
Step 3: Spread out the tent and stake the corners
Unroll the tent body on the footprint with the door where you want it. If your tent and footprint share corner buckles or grommets, Big Agnes suggests staking both at once with the same stakes, before the poles go in.
- Start at the corners and pull the floor taut, as the BLM advises, then stake the remaining points.
- Drive stakes at a 45-degree angle, angled away from the tent, and push or hammer them all the way in (Big Agnes).
- In hard ground, a rubber mallet or a flat rock helps. In sand or snow, wide stakes or buried "deadman" anchors hold better.
Some tents pitch more easily with the poles in first and the stakes after; follow your tent's instructions if they say so.
Step 4: Assemble and attach the poles
Unfold each pole and make sure every segment is fully seated in the next one before you bend it, as MSR advises. Then:
- Match each pole to its place. Many tents color-code the pole ends and the corner grommets.
- Seat the pole tips in the grommets or corner pockets.
- Clip the tent body to the poles, or slide the poles through the sleeves. Push poles through sleeves rather than pulling, so the segments don't come apart inside.
The tent stands up as the clips go on.
Step 5: Put on the rainfly
Even on a clear night, put the fly on: dew and surprise showers happen.
- Find the door on the fly and line it up with the tent door. Many flies have color-coded corners too.
- Big Agnes's trick for wind: attach one corner of the fly first, then throw it over the poles, so it can't turn into a kite.
- Buckle or clip the remaining corners and fasten any hook-and-loop tabs to the poles underneath.
- Tension the corner straps so the fly is taut and doesn't touch the tent body. Big Agnes says to keep a healthy gap between fly and tent for ventilation; where they touch, condensation and rain wick through.
Step 6: Stake out the guylines and vestibule
- Use the guylines every time. Big Agnes says so, and that in rain the tent should be staked out taut, without wrinkles or loose sections, with all guylines in use.
- Run each guyline straight out from its attachment point, stake it, and snug the tensioner.
- Stake out the vestibules so your boots and pack stay dry under them.
- Walk around once and tighten anything that sags. Big Agnes notes that wet nylon stretches and sags, so retighten before bed if it rains.
Taking it down
Pack up in reverse: guylines, fly, poles, stakes. Shake out the tent before you roll it up. If it's wet, dry it at home as soon as you can. Our guide on how to clean a tent covers drying and storage so it doesn't mildew.
Common mistakes
| Mistake | What happens | Fix |
|---|---|---|
| Footprint sticks out past the floor | Rain runs under the tent | Fold it under |
| Fly touching the tent body | Condensation and leaks | Tension the fly straps and guylines |
| Stakes straight up or half in | Tent pulls loose in wind | 45 degrees, all the way in |
| Pitching in a dip | Puddle under the floor | Slightly higher, flat ground |
| Skipping the guylines | Flapping, sagging, wet walls | Stake them out every time |
| First pitch at camp after dark | Missing parts, frustration | Practice at home |
Packing for the trip? Our camping checklist has the tent, stakes, mallet and everything else, with a printable PDF.